This work investigated, using a 3-D modelling, the influences of the magnitude and the inclination angle of an electromagnetic field (EMF) carried by AM radio waves on the current and the voltage of a polycrystalline silicon PV cell.
The electrons transport equations were solved to find the density of electrons and then to derive the current density and the voltage. Through numerical simulation, the effects of both the magnitude and the inclination angle of the EMF on the density of electrons, the current density and the open circuit voltage were studied.
Results of simulation showed that depending on the inclination angle (0 rad; π/2 rad and π rad), the EMF acts differently on the electrical parameters (Jsc and Voc). The analysis also showed that, regardless of the inclination angle of the EMF, there is an open circuit current (Joc) proportional to the magnitude of the EMF (inversely proportional to the distance). This current (Joc) is lost by Joule heating either at the junction (θ = 0 rad) or in the base (θ = π/2 rad and θ = π rad). Finally, the analysis showed that, for θ = π rad (reverse polarization of the PV cell), there is an operating domain (Sf ≤ Sfeq) in which the PV cell is blocked. And another operating domain (Sf > Sfeq) in which the PV cell is a current generator unlike a PN junction diode which remains blocked in reverse bias.

This paper investigated, using 1-D analysis, the effect of low energy electrons emitted from Promethium – 147 (Pm-147) on the performance of a silicon PV cell. The Pm-147 source is chosen due to the penetration depth of beta particles with the average kinetic energy of 62.5 KeV emitted from Pm-147, because at this depth the are able to generate charge carriers right down to the base. The continuity equation of excess minority carrier is solved respectively in the emitter for excess holes and in the base for excess electrons. The analytical expression of the density of electrons and holes for each part of the solar cell is derived and, in turn, the electrical parameters (Jsc, Voc, FF, η) of the PV cell are found. The influence of radiation flux on short-circuit current density (Jsc), Open circuit voltage (Voc), fill factor (FF) and conversion efficiency (η) are discussed. if we vary the flux of incident particles up to the value of 3.1010 cm-2, we achieve a relative increase in the PV Cell conversion efficiency of the order of 0.2743 %.