Volume 29, Issue 3, June 2020, Pages 821–830
Aniobi C.C.1, Ezeh E.2, Okeke O.3, Akagha C.I.4, and Alieze A.B.5
1 Department of Community Medicine, University of , Enugu Campus, Niger, Nigeria
2 Chemical Engineering Department, Nnamdi Azikiwe University, Awka, Nigeria
3 Plastic Production Unit, Scientific Equipment Development Institute, Enugu, Nigeria
4 Chemistry Department, Federal University of Technology, Owerri, Nigeria
5 Science Laboratory Technology Department (Chemistry Option), Federal College of Agriculture, Ishiagu-Ebonyi State, Nigeria
Original language: English
Copyright © 2020 ISSR Journals. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Studies were carried out to evaluate the environmental impact of abattoir effluents discharge on the quality of well water in Abakpa, Enugu State-Nigeria using standard analytical procedures and instrumentation. The samples were collected and the physiochemical parameters were analyzed using standard techniques. The heavy metals analyzed in the water samples involved wet digestion and aspiration of the digest onto the spectrophotometer for the determination of the concentration of the studied metals. The mean range of values for samples S1, S2, S3, and control were 6.64-7.07, 3.03-6.26NTU, 71.02-117.32, μ5/cm and 116.29-200.61mg/l, 41.04-53.08mg/l, 1.04-2.88mg/l and 22.14-29.12 mg/l for pH, turbidity, electrical conductivity, total dissolved solids, chloride ions, biological oxygen demand and nitrate ions respectively. The mean range of values for the heavy metals analyzed in the water samples were 2.14-12.31, 0.38-1.59, 1.03-2.81, 0.06-0.26 and 0.003-0.008μg/g for Zn, Cu, Fe, Pb and As respectively. Sampling points S1 and S2 consistently exhibited higher values for all the studied physiochemical parameters and heavy metals than other sampling points (S3 and control). Of all the studied physicochemical parameters and heavy metals, only turbidity and Zn in sampling point S1 and Pb in sampling points S1 and S2 exceeded the recommended permissible limits for a safe drinking water. The study reveals that the proximity of sampling points S1 and S2 to the abattoir, where effluent discharge occurs, could have been the reason for the higher values they exhibited for all the studied parameters than the other sampling points (S3 and control). The levels of the studied physicochemical parameters and heavy metals in samples S1, S2, S3 and control were statistically significant. The study therefore recommends that environmental health agencies should ensure that future sitting of abattoir around residential areas are prohibited and those still operational are strictly supervised to ensure that they operate within standard sanitary guidelines in order to protect the health of the people from water and food borne illnesses.
Author Keywords: Abattoir effluents, Heavy metals, Physicochemical parameters, Well water, and Pollution.
Aniobi C.C.1, Ezeh E.2, Okeke O.3, Akagha C.I.4, and Alieze A.B.5
1 Department of Community Medicine, University of , Enugu Campus, Niger, Nigeria
2 Chemical Engineering Department, Nnamdi Azikiwe University, Awka, Nigeria
3 Plastic Production Unit, Scientific Equipment Development Institute, Enugu, Nigeria
4 Chemistry Department, Federal University of Technology, Owerri, Nigeria
5 Science Laboratory Technology Department (Chemistry Option), Federal College of Agriculture, Ishiagu-Ebonyi State, Nigeria
Original language: English
Copyright © 2020 ISSR Journals. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Abstract
Studies were carried out to evaluate the environmental impact of abattoir effluents discharge on the quality of well water in Abakpa, Enugu State-Nigeria using standard analytical procedures and instrumentation. The samples were collected and the physiochemical parameters were analyzed using standard techniques. The heavy metals analyzed in the water samples involved wet digestion and aspiration of the digest onto the spectrophotometer for the determination of the concentration of the studied metals. The mean range of values for samples S1, S2, S3, and control were 6.64-7.07, 3.03-6.26NTU, 71.02-117.32, μ5/cm and 116.29-200.61mg/l, 41.04-53.08mg/l, 1.04-2.88mg/l and 22.14-29.12 mg/l for pH, turbidity, electrical conductivity, total dissolved solids, chloride ions, biological oxygen demand and nitrate ions respectively. The mean range of values for the heavy metals analyzed in the water samples were 2.14-12.31, 0.38-1.59, 1.03-2.81, 0.06-0.26 and 0.003-0.008μg/g for Zn, Cu, Fe, Pb and As respectively. Sampling points S1 and S2 consistently exhibited higher values for all the studied physiochemical parameters and heavy metals than other sampling points (S3 and control). Of all the studied physicochemical parameters and heavy metals, only turbidity and Zn in sampling point S1 and Pb in sampling points S1 and S2 exceeded the recommended permissible limits for a safe drinking water. The study reveals that the proximity of sampling points S1 and S2 to the abattoir, where effluent discharge occurs, could have been the reason for the higher values they exhibited for all the studied parameters than the other sampling points (S3 and control). The levels of the studied physicochemical parameters and heavy metals in samples S1, S2, S3 and control were statistically significant. The study therefore recommends that environmental health agencies should ensure that future sitting of abattoir around residential areas are prohibited and those still operational are strictly supervised to ensure that they operate within standard sanitary guidelines in order to protect the health of the people from water and food borne illnesses.
Author Keywords: Abattoir effluents, Heavy metals, Physicochemical parameters, Well water, and Pollution.
How to Cite this Article
Aniobi C.C., Ezeh E., Okeke O., Akagha C.I., and Alieze A.B., “Environmental Impact of Abattoir Effluents Discharge on the Quality of Well Water in Abakpa, Enugu State-Nigeria,” International Journal of Innovation and Applied Studies, vol. 29, no. 3, pp. 821–830, June 2020.
