Volume 9, Issue 3, November 2014, Pages 1281–1290
Mouhssine Chahbouni1, S. Boutahari2, and Driss Amegouz3
1 Laboratoire de Productique, Energétique et Développement Durable, Université Sidi Mohammed Ben Abdellah/Ecole Supérieure de Technologie, BP 2427 Route Imouzzer30000 Fès, Morocco
2 Laboratoire de Productique, Energétique et Développement Durable, Université Sidi Mohammed Ben Abdellah/Ecole Supérieure de Technologie, BP 2427 Route Imouzzer30000 Fès, Morocco
3 Laboratoire de Productique, Energétique et Développement Durable, Université Sidi Mohammed Ben Abdellah/Ecole Supérieure de Technologie, BP 2427 Route Imouzzer30000 Fès, Morocco
Original language: English
Copyright © 2014 ISSR Journals. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
The objective of this paper is to present the analysis of geometric tolerances of the assembly design with the deviations and clearance method, for this we will study initially the tolerance analysis using the worst case method, in a second step we will integrate statistical Tolerancing approach, and finally we will integrate form deviations of the parts to study the impact of these deviations on the tolerance analysis.
To illustrate this process of analysis we used a classic case of assembly and we considered the location tolerance (perpendicularity) and the form tolerance (flatness).
Finally, a comparative study between the two statistical methods was illustrated.
Author Keywords: Tolerance analysis, Deviations and Clearance method, Worst case method, Form deviations, Statistical method.
Mouhssine Chahbouni1, S. Boutahari2, and Driss Amegouz3
1 Laboratoire de Productique, Energétique et Développement Durable, Université Sidi Mohammed Ben Abdellah/Ecole Supérieure de Technologie, BP 2427 Route Imouzzer30000 Fès, Morocco
2 Laboratoire de Productique, Energétique et Développement Durable, Université Sidi Mohammed Ben Abdellah/Ecole Supérieure de Technologie, BP 2427 Route Imouzzer30000 Fès, Morocco
3 Laboratoire de Productique, Energétique et Développement Durable, Université Sidi Mohammed Ben Abdellah/Ecole Supérieure de Technologie, BP 2427 Route Imouzzer30000 Fès, Morocco
Original language: English
Copyright © 2014 ISSR Journals. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Abstract
The objective of this paper is to present the analysis of geometric tolerances of the assembly design with the deviations and clearance method, for this we will study initially the tolerance analysis using the worst case method, in a second step we will integrate statistical Tolerancing approach, and finally we will integrate form deviations of the parts to study the impact of these deviations on the tolerance analysis.
To illustrate this process of analysis we used a classic case of assembly and we considered the location tolerance (perpendicularity) and the form tolerance (flatness).
Finally, a comparative study between the two statistical methods was illustrated.
Author Keywords: Tolerance analysis, Deviations and Clearance method, Worst case method, Form deviations, Statistical method.
How to Cite this Article
Mouhssine Chahbouni, S. Boutahari, and Driss Amegouz, “Statistical tolerance analysis by integrating form deviations,” International Journal of Innovation and Applied Studies, vol. 9, no. 3, pp. 1281–1290, November 2014.
